Rear Panel Controls - Hartke Kickback KB12 Bedienungsanleitung

Rear Panel Controls

1
2 3
1. AC Inlet - Attach the grounded AC power cord here to connect your amplifier to mains
power. This cord comes supplied with the appropriate plug for your geographic area.
CAUTION: Do not use an adapter to defeat the third grounding pin on this plug or
severe electric shock may result!
2. Fuse Holder - The fuse holder comes from the factory with the appropriately rated
fuse for your model. If you need to change this fuse for any reason, replace it with
one that has the same exact rating.
3. Voltage Selection Switch - This switch is used to select the amplifiers operating voltage
NOTE: Before using your speaker, be sure the voltage selection switch is set to
the correct voltage for your country. Be sure to install the properly rated fuse when
changing the operating voltage.
4. Speaker Output Jack - The internal speaker is normally connected to this standard
unbalanced ¼" jack.
Note: Because of the high power levels and low frequency content of the signal
generated by the Kickback amplifier, we recommend the use of the provided
internal speaker only. If you do wish to connect an external speaker, use only
appropriately rated 4 ohm speaker cabinets that are specifically designed for bass
instruments.
Kickback Series Combos
CAUTION ATTENTION
4
7