HEADRUSH Looperboard Schnellstartanleitung Seite 2

Quickstart Guide (English)
Introduction
Box Contents
Looperboard
USB Cable
Power Adapter
Important: This Quickstart Guide covers basic functionality of the HeadRush Looperboard. Visit
headrushfx.com to download the full, detailed User Guide, which may also contain additional
information for new features and improvements after firmware updates.
Support
For the latest information about this product (documentation, technical specifications, system
requirements, compatibility information, etc.) and product registration, visit headrushfx.com.
For additional product support, visit headrushfx.com/support.
Get Started!
Here are some steps to start recording quickly:
1. Make sure your guitar or other sound source is
connected to an input on the rear panel, and set
the input gain level by turning the Input (1–4)
knob for the input you want to use.
2. Tap Fixed at the bottom of the touchscreen
(Fixed Mode enables playback and/or recording
of all tracks simultaneously).
3. Press the •Rec/Play/Dub footswitch for Track 1,
and start recording!
4. When you are done recording the first track,
press that •Rec/Play/Dub footswitch again. Your
recording will return to the beginning and start
looping in its "playback mode" (the waveform will
turn green).
Press the •Rec/Play/Dub footswitch once more
to enter the "overdub mode" for that track (the
waveform will turn red). You can now overdub
more playing on that track.
5. Repeat Steps 4–5 for Tracks 2–4.
6. Tap the meter icon at the top of the
touchscreen to enter the Meter page. Tap and
drag the gray line at the top of a meter to adjust
its level.
See Basic Operation
2
Software Download Card
Quickstart Guide
Safety & Warranty Manual
to learn more.