HEADRUSH Looperboard Schnellstartanleitung Seite 14

Audio Routing
You can use the Audio Routing page to control where your input, looper track, and output audio
signals are sent. These settings are global settings (not per loop) so that you can quickly configure
Looperboard to work best for your gear and performance settings.
To show the Audio Routing page, tap the ••• icon and then tap Audio Routing.
To show the page for the inputs, tracks, or outputs, tap Input Setup, Track Setup or Output
Setup respectively.
Input Setup
To adjust the level of an input signal, turn
its Input Gain knob (1–4) on the top panel.
To adjust the panning of an input signal,
tap its Pan slider and drag left or right.
You can enlarge this slider to make more
detailed adjustments by double-tapping.
To select an output to directly monitor
the input signal, tap the desired Output
1–4 button or the headphone icon under
Dry Send. Audio signal from the input will
be sent directly to the selected output(s).
Use the Master and Phones knobs to
adjust the output volume level of the
outputs and phones, respectively.
To stereo link your inputs if you are using a stereo audio source (e.g., drum machine,
keyboard, etc.), tap the On button for Inputs 1+2 and/or Inputs 3+4 under Stereo Link on the
right side of the touchscreen. Tap the Off button to disable stereo link.
Monitor Setup
You can use the Monitor Setup page for
listening to your inputs while recording,
overdubbing, and playing back loops. You
can control the level of each input, as well
as which output that you would like to
monitor to them on.
To adjust the monitor level of an input,
tap and drag the orange line at the top of
its meter.
To select an output for monitoring, tap
the desired Output
headphone icon below an input meter.
14
1–4 button or