Unit Description; Preparing The Appliance For Use - Duronic SAD Light Gebrauchsanleitung

Unit Description

1. Screen
2. Brackets
3. Mounting hole
4. Carrying handle
5. Fold-out stand
6. On/off switch
7. Retaining clips
8. Reflector
9. Tubes, 2 x 36W
16

8. Preparing the appliance for use

Setup
1. Remove the unit from the packaging.
2. Place the unit on a solid surface, such as a table, and adjust the folding
tripod.
3. It is recommended that you keep your face 20 - 50 cm away from the light
during use.
Mains connection
Connect the unit only to the mains voltage listed on the type plate.
- Push the plug completely into the mains socket.
Note
- Ensure that there is a socket near the place where the lamp will stand.
- Lay the mains cable in such a way that no one can trip over it.
Fastening of Daylight on the wall
There is a mounting hole on the back side of the Daylight. At this mounting
hole the unit can be fixed on the well with screw. Depending on the type of
wall, an appropriate screw must be used, may be with pegs. E.g. for concrete
wall, M4, 25mm long Stainless Steel Self-Tapping Screw which is screwed into
a anchor. The screw and the anchor are not included in the scope of delivery.
Important
- If the mounting hole or back enclosure is cracked or damaged. Do not fix
the Daylight on the wall. Please contact customer service or the dealer for
assistance.
17