Symbol LL500 Omnilink Kurzübersicht Seite 12

9
Get Set
Power-up your host terminal. You will hear three beeps and see
a green light on the LL 500.
Before you can actually start, you have to scan two bar codes.
The bar code below will set all programmable parameters to
their default values.
Scan this bar code now.
You should have just heard a warble tone from the LL 500.
If you are connected to a RS-232C terminal, you may need to
change some of the defaults. Consult the LL 500 Product
Reference Guide for a description of those parameters, and their
associated bar codes.
The second bar code you must scan is a Host Type. The LL 500
will not operate unless you select your host type. Bar codes for
the most popular host types begin on page 71. Scan a Host Type
now, then go the next page.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com