Rear Panel; Speaker Outputs - Aguilar Tone Hammer 500 Bedienungsanleitung

Effects Loop Section:
The effects loop section is intended to be used with professional rack gear
with a nominal input level of 4dBu. Effects pedals should be used in front
of the amp.
D.I. Section:
D.I. Nominal Output Level: -20dBu
D.I. Pre/Post Button:
Pre - Your signal goes to the D.I. XLR output jack before your Gain and EQ
settings, but after the –10dB input pad.
Post – Gain, Drive, EQ and effects will be sent to the D.I. XLR output jack.
In this setting adjustments to the Master control will only affect the output
to your speaker cabinets, not the signal going to the D.I.
Lift/Ground: If there is a hum when using the D.I. there may be a ground
loop. In many cases pushing in the Lift/Ground button can fix this
problem.
* Note: The Tone Hammer 500 will not be harmed by phantom power
through the D.I. Phantom power is a power supply that can be switched
on at the channel input of some mixing consoles and is used to power
some types of microphones. Use of phantom power (usually labeled as
48V) will have no effect on the D.I. or the amplifier in general.
B. Rear Panel Features

Speaker Outputs:

Two speakon outputs are provided. Any combination may be used as
long as the load does not go below 4 ohms. The speakon jacks are wired
+1, -1
Tuner Output:
One ¼" Tuner output is provided. When the amplifier is muted your signal
will still reach the tuner.
Input Voltage Selector:
The Input Voltage switch allows you to change the operating voltage if
you travel with your Tone Hammer 500. You can select between 115V for
100-120V and 230V for 220, 230 or 240V.
Page 5