AUDIOropa RX-1U Bedienungsanleitung Seite 14

4. Using the RX-1U
4.1 Volume adjustment
Adjust the volume control initially to a low volume to protect your ears. The vo-
lume increases when you turn the dial in the direction of »5« and it decreases
when you turn the dial in the direction of »0«.
4.2 Switching on and off
Place the receiver on your ears. The receiver switches on automatically when
the speaker arms are expanded.
The receiver is switched off automatically when taking it off.
4.3 Reception
Reception will start as soon as the device is switched on. The blue indicator
LED will blink twice every second during an active connection with a Xepton
transmitter. The indicator LED will begin to blink if there is no active connection.
4.3 Connecting to a Xepton transmitter
Switch a Xepton transmitter (TX-1, TRX-1, T-1, or RP-1) on. The transmitter
should be set to MASTER-priority (except TX-1, which is MASTER by default).
To make sure that the RX-1U connects to the transmission of the intended trans-
mitter, the receiver should be in close proximity to this transmitter. Place the
RX-1U on your ears and use a pointed object to press the internal CONNECT-
button for 2 seconds. The LED blinks in fast succession and the receiver will
now connect with the transmitter.
When switching the receiver off and on again, the receiver will automatically
connect to the previously connected transmitter, given that its channel group
number has not been changed since then. If the channel group number of the
respective transmitter has changed, the receiver needs to be reconnected by
means of the CONNECT button, as described above.
4.4 Power supply / recharge
The device is equipped with a rechargeable lithium-polymer battery of 3,7 V
/ 280 mAh. Place the RX-1U in the charging dock of the respective charger
(single charger, charging case DC-10/1).
The red charging status LED is lit during recharge. The LED switches off when
the battery is fully loaded.
English 14