DF-models KL-35 Bedienungsanleitung Seite 27

2. Programming step:
> Start the programming mode.
> Hold the set button for 3 more seconds after the green LED has blinked once.
> The green LED will blink twice.
You are in the second programming step "drag brake".
> To set the second programming step "drag brake", release the set button and press it again.
> The red LED will blink once for the first selection option: drag brake 0%
> If you want to quit programming here, switch off the speed controller and and restart it
subsequently.
> Or: Press the set button again until you have reached the desired value.
Press the set button twice, the LED will blink twice:
Drag brake 5%
Press the set button 3 times, the LED will blink 3 times:
Drag brake 10%...
LED blinks 4 times: drag brake 15%
LED blinks 5 times: drag brake 20%
LED blinks 6 times: drag brake 25%
LED blinks 7 times: drag brake 30%
LED blinks 8 times: drag brake 40%
3. Programing step:
> Start the programming mode.
> Press and hold the set button for 3 more seconds until the green LED has blinked twice.
> The green LED blinks three times.
You are in the third programming step "undervoltage protection".
> To set the third programming step "undervoltage protection", release the set button and
press it again.
The red LED will blink once for the first selection option: undervoltage protection "OFF"
> If you want to quit programming here, switch off the speed controller and and restart it
subsequently.
-  -