Werbung
Verfügbare Sprachen
Verfügbare Sprachen
It is recommended to run the power supply cable opposite of the audio cable to avoid interference.
•
Connect the +12 V-terminal of the amplifier with the positive terminal of the car battery and
•
interconnect a fuse.
Connect the GND-terminal of the amplifier with the negative terminal of the car battery.
•
Connect the REM-terminal of the amplifier with the radio. If there is no separate output for this purpose
•
at your car radio use the antenna terminal.
Connect the speakers to the amplifier. Turn LEVEL [10] to the lowest input sensitivity. Now turn on the
•
radio and adjust its volume to 80%. Adjust LEVEL [10] that there is no distortion.
In normal connection mode, which means one speaker at every channel, the minimum impedance
•
should not fall short of 2 Ω.
In subwoofer mode, which means the speaker outputs are bridged, the minimum impedance should not
•
fall short of 4 Ω.
Never connect the 12 V power supply to the speaker output terminals.
•
Modes of Operation:
1. 2-Channel Mode (Subwoofer Mode):
SPEAKER OUTPUT: Connect one speaker to the bridged CH1/CH2 and the other one to the bridged CH3/CH4.
MODE: For both - CH1/CH2 and CH3/CH4- set it to MO (Mono).
X-OVER: For both - CH1/CH2 and CH3/CH4- set it to LOW PASS to let the low frequencies pass and to lock the
high ones.
ETT Distribution GmbH Schmalbachstraße 16 38112 Braunschweig
Nachdruck oder Vervielfältigung nur mit ausdrücklicher Genehmigung Stand 12/2016
1751231
Werbung
