Mophie juice pack H2PRO Bedienungsanleitung Seite 12

c) Remove the phone from the case by pushing on the bottom of the
phone with your finger until the phone disconnects from the case's
built-in Lightning connector. Do NOT lift the phone away from the
case or you may damage the Lightning connector.
NOTE: If the juice pack H
the empty case and rinse the outside with fresh water to prevent salt
accumulation that can damage the clear membrane. Thoroughly dry the
outside of the case (and your hands) before opening it.
3. Charging your iPhone using the juice pack H 2 PRO case
a) To charge your iPhone from the juice pack H
on/off button on the case (to the right of the four status LEDs) so
that the battery symbol and charge indicator appear on the iPhone
screen and you hear a chirp from the iPhone. This indicates that the
phone is charging and/or using the power from the juice pack case
rather than from the phone itself.
b) To stop charging your iPhone and put the juice pack H
into standby mode, press the on/off button again so that the charge
indicator no longer appears on the iPhone screen.
If your iPhone is drained of power when you press the on/off button to
charge it, the juice pack H
phone. If your iPhone is fully charged when you press the on/off button,
the juice pack case will act as your primary battery and no power will be
used from the iPhone's internal battery until the case's battery is depleted.
4. Checking your juice pack H 2 PRO case's charging status
Press the status button on the back of the juice pack H
of the four status LEDs) and the LEDs will indicate the case's charge level.
Four LEDs means that the juice pack case is fully charged, while one LED
means that it's almost empty. Know before you go.
Your juice pack H
need charging:
a) Open the USB port cover.
b) Use the supplied USB micro cable to connect the case to your computer
or any power source with a USB out, like the USB wall adapter included
with your iPhone.
Normal charging should take only two or three hours for maximum power.
The LEDs located on the back of the case will blink for 30 seconds to
indicate the juice pack H
stop blinking, it does not mean the case has stopped charging.
Open the juice pack H
the included pass-through headphone cable through the port and
into the headphone jack on the iPhone. Connect your headphones to
the pass-through cable.
PRO has been exposed to salt water, seal
2
PRO case will immediately begin charging your
2
5. Charging your juice pack H 2 PRO case
PRO case comes charged and ready to go. When it does
2
PRO case has begun charging. When the LEDs
2
6. Connecting headphones
PRO case's headphone port cover and insert
2
12 12
PRO case, press the
2
PRO case back
2
PRO case (to the left
2