Adjustments - Buttner Elektronik MT iQ Solar Pro Bedienungsanleitung

Adjustments

For the correct displaying of solar power bar graph it is
essential to store the maximum measured solar power
EN
Entering setup menu:
Press
u
selection "Back" (quits menu) is now highlighted. Each
further key-press on
is pressed for 10 seconds, the menu will be quit again.
Calibrating the maximum solar power: RESET 100 %.
Advice
i
Change the menu to the function "Reset 100 %". Keep
push-button
end and "OK" is displayed. "Reset 100 %" completes the
calibration and the last adjustment is permanently stored.
Alternatively, you can also wait 10 seconds to store and quit.
28
and hold for 5 seconds > Entering the menu. Menu
u
Important how to achieve the correct max solar
power:
Solar radiation on the modules should be at their
maximum. At this time the battery should NOT be
fully charged. In this case the solar regulator ope-
rates at reduced charge power and therefore solar
power can't be stored at its maximum.
pressed until the progress bar reaches at the
u
BÜTTNER ELEKTRONIK – MT iQ Solar
allows scrolling the menu. If no key
Pro