Werbung
RX+45e
Instructions for use
Where to put your radio
It is important that you consider carefully in advance where your radio will be situated
and make sure that it is:
* on a flat and stable surface
Note: Never place your radio on antique or polished surfaces.
* within 1.4 metres of a power socket
* where you can fully extend the telescopic aerial
* away from bright sunlight or heat sources, such as a radiator
* not in a humid or very damp place such as a bathroom
Setting up
1. Connect the mains power lead into the socket on the back of the radio.
2. Fully extend the radio aerial in a vertical position to obtain the maximum signal
strength.
3. Plug the power adaptor into the mains power wall socket and switch on.
4. Your radio will switch on and 'Welcome to Digital Radio' will be displayed, followed by
time and your radio enters into standby mode. Press Standby/Mode button to switch on,if
it's the first time to power on,defaulted as DAB mode, your radio perform Autotune Full
Scan for DAB/DAB+ radio stations (if not the first time,it will enter mode of last use). A
progress bar will show the progress of the scan and the number of stations found during
the scan will also be displayed. When the scan is complete your radio will select the first
available station and begin to play.
Note: The DAB radio station list is stored in the memory and so the next time you switch
your radio on, the station search does not take place.
Switch on/off
Press and release the 'Standby' button on the top of the radio to switch the radio on.
Press and hold the 'Standby' button on the top of the radio to switch the radio off
(Standby mode).
Time and date
The first time you listen to DAB radio, the time and date of your product will be
synchronised automatically to that broadcast by the DAB service in 24 hour mode; which
is in line with daylight saving, so there is no need to set the time and date manually.
Changing modes (DAB/FM)
Briefly press the 'Standby' button on the top of the radio to switch between DAB and FM
mode.
Adjusting the volume
Use the left hand rotary control to adjust the volume. Turn clockwise to increase the
volume and anti-clockwise to decrease the volume.
Headphone socket
You can connect headphones (not included) to your radio. The headphone socket can be
found on the back of the radio. When you have headphones connected the radio speakers
are switched off and all sound is via the headphones.
Note: Headphones will need a 3.5mm stereo plug.
41
Werbung
