Seite 32
Brand name: Blaupunkt Responsible party: M3 Electronic GmbH Gutenbergstrasse 5, D-65830 Kriftel. Germany Hereby, Blaupunkt Competence Center Audio M3 Electronic GmbH, declares that this Class 1 equipment is in compliance with the essential requirement and other relevant provisions of Directive 1999/5/EC.
Seite 33
12. ESD WARNING – the display does not function properly or not reaction to operation of any the control may due to the electrostatic discharge. Switch off and unplug the set. Reconnect after a few seconds. 13. DAMAGE REQUIRING SERVICE – the appliance should be serviced by qualified service personal when: a.
Seite 34
26. Ensure a minimum distance of 5cm around the apparatus for sufficient ventilation. 27. The ventilation should not be impeded by covering the ventilation opening with items such as newspapers, table-cloths, curtains, etc. 28. The batteries should be drawn to the environmental aspects of batter y disposal. CAUTION The following label has been affixed to the unit, listing the proper procedure for working with the laser beam:...
POWER SOURCES AC POWER You can power your portable system by plugging the detachable AC power cord into the AC inlet at the back of the unit and into a wall AC power outlet. Check that the rated voltage of your appliance matches your local voltage. Make sure that the AC power cord is fully inserted into the appliance.
BASIC FUNCTION GENERAL OPERATION - At standby mode, press the "POWER/FUNCTION" button to switch on the system. (FM radio mode as default mode when switch on the system.) - Press the “POWER/FUNCTION" button to switch the system to CD mode. (Only have Radio mode and CD mode.) - Press and hold the “POWER/FUNCTION"...
Seite 38
PLAYBACK 1. Press the “ POWER/FUNCTION " button to select “CD” mode. 2. Open the CD door and place a CD / MP3 disc with the label up in the CD compartment. 3. Close the CD door. 4. Focus search is performed if disc is inside. For CD disc - Total number of tracks is read and appears on the display.
OTHER FEATURES CLOCK SETTING 1. Press and hold the “ POWER/FUNCTION ” button to switch unit at standby mode. 2. Press and hold the “SLEEP / TIME SET” button to entry clock set mode. The display will show “24H” and flashing. 3.
SNOOZE When the alarm is triggered. You may press the “SNOOZE” button to delay the alarm for another 9 minutes. SLEEP 1. In CD mode, press and hold the "SLEEP / TIME SET" button for 3 seconds, display will show “SLEEP 90”. That means, after 90 minutes, appliance will automatically turn to standby mode.
Seite 41
There are separate collection systems for recycling in the EU. For more information, please contact the local authority or your retailer where you purchased the product. All rights reserved by Blaupunkt Competence Center Audio M3 Electronic GmbH. This material may be reproduced, copied or distributed for personal use only.