Boil-Dry Protection; Cleaning And Care - Team TT 1 Gebrauchsanleitung

Fax +32 2 359 95 50

BEFORE THE FIRST OPERATION
It is necessary to rinse your jug kettle and tea pot before their first use. Rinse the tea pot under
running water. To rinse the jug kettle, fill it with cold water and switch it on. When the water
boils, let the appliance cool down, rinse it and repeat the process 2 or 3 times making sure only
to put clear water in it.
USING THE JUG KETTLE

Always remove the jug from the power base before filling it.

Raise the lid by pressing its release button (1) situated on top of the lid and and fill the jug
with fresh water paying attention not to fill under the minimum mark and above the
maximum mark on the kettle. You can see the level thanks to the transparent water level
indicator. It is absolutely necessary to follow this instruction.

Close the lid by pressing it down until it you hear a click. Make sure it closes correctly.

Put the jug onto the power base (6), insert the cord into the opening in the back of the
base (11) and insert the plug into the wall socket. Put the switch (2) situated on the
handle of the jug kettle to position "1". The pilot light (3) comes on, indicating that the jug
kettle is heating.

The jug kettle will switch off automatically when the water has boiled (the pilot light comes
out) but you can also stop it anytime by putting the kettle's switch in "0" position.

For instant reboiling, wait until water has cooled down and switch on the appliance again.
USING THE TEA POT AND THE HOT PLATE
 Open the lid and fill the filter (4) with the desired amount of bulk tea (never use tea bags).
 After having boiled water with the jug kettle, pour the water gently in the tea pot, through
the filter.
 The level indicated on the teapot corresponds to the number of cups (4, 6, 8, 10).
 Press the tea gently with the pusher (5) of the lid.
 If you want to keep the tea warm, put the teapot on the hot plate (7) and put the switch
of the base (10) on the "1" position; the pilot light (8) on the front side of the base
illuminates to indicate that the base is switched on. Caution: this system only keeps the
tea warm; it does not allow to boil water. However, make sure not to let an empty teapot
on the hot plate when it is operating.

BOIL-DRY PROTECTION


This jug kettle is protected with an automatic safety device if accidentally switched on
without water.

Should this happen, switch off the appliance and wait about 10 minutes for the element to
cool. Then fill the jug kettle with cold water. This will reset the safety device. The kettle may
then be used as normal.

Should the problem persist, please contact the nearest customer service.

CLEANING AND CARE


Always unplug the base and let it cool down before cleaning. Detach the cord from the
basis before cleaning it.

Clean the plastic and glass parts with soft cloth. Use a soft brush to clean the limescale on
the interior parts of the jug kettle.

Never use abrasive products.

Never immerse the jug kettle and the base in water or any other liquid.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
8
Assembly page 8/28
TEAM TT 1 - 060110