Greenlee HW3 Bedienungsanleitung Seite 5

IMPORTANT SAFETY INFORMATION
• Wear protective gloves when handling, removing
and installing drill bits. Drill bits can cut even when
stationary.
• Inspect tool before use. Replace any worn or
damaged parts. A damaged or improperly
assembled tool can malfunction, injuring nearby
personnel.
• Inspect the hydraulic hoses and couplings every
operating day. Repair or replace if leakage, cracking,
wear, or damage is evident. Damaged hoses or cou-
plings can fail, resulting in injury or property damage.
• Use this tool for manufacturer's intended use only.
Use other than that which is described in this
manual could result in injury or property damage.
• Make sure all bystanders are clear of the work area
when handling, starting, and operating the tool.
Nearby personnel can be injured by flying parts in the
event of a tool malfunction.
Prolonged exposure to vibration or very repetitive hand
and arm movements may cause injury. Stop using
any tool if discomfort, tingling feeling, or pain occurs.
Consult a physician before resuming use of the tool.
Greenlee / A Textron Company
HW3 Impact Wrench
Procedure for connecting or disconnecting hydraulic
hoses, fittings, or components:
1. Move the flow lever on the hydraulic power source
to the OFF position.
2. Stop the hydraulic power source.
3. Follow the sequence under "Hose Connections" to
prevent pressure buildup. In case some pressure
has built up, loosen hoses, fittings, or components
slowly.
Emergency stop procedure:
1. Release the trigger.
2. Shut off the hydraulic power source.
Note: Keep all decals clean and legible, and replace
when necessary.
5
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070