Angle Grinder - Elem Co-Ligne MFA115C-G Handbuch

WARNING
Read this manual carefully before using the
machine, for your own safety.
SAFETY INSTRUCTIONS
When using the machine, always observe
the enclosed safety instructions as well as
the additional safety instructions.
The following symbols are used throughout
this manual:
Denotes risk of personal
injury or damage to the tool.
You will find the following symbols on the
machine:
Take measures to protect
ADDITIONAL SAFETY INSTRUCTIONS
FOR ANGLE GRINDERS
Do not cut or grind light
metal with a magnesium
content exceeding 80%;
since this type of metal is
Do not use any other accessories than
grinding wheels.
Make sure that the speed stated on the
grinding wheel is larger or the same as
the speed of the angle grinder given on
the nameplate.
Do not cut workpieces requiring a maximum
depth of cut exceeding that of the grinding wheel.
Make sure that the grinding wheel has the
correct dimensions and fits properly on
the spindle.
Treat grinding wheels with great care in
accordance with the instructions supplied
with the grinding wheel.
Inspect the grinding wheel before every
use. Do not use cracked or otherwise
damaged grinding discs.
Make sure that the grinding wheel is
mounted in accordance with the instructions.
After mounting the grinding wheel let the
GB

ANGLE GRINDER

Fire hazard.
your eyes.
Consult the manual.
flammable.
machine run at no load speed in a safe
area. If the machine vibrates strongly or if
you see damages in the grinding wheel,
switch off the machine immediately and
try to establish the cause.
Do not use adapters or other aids to
mount grinding wheels with a different
spindle diameter.
Make sure that the workpiece is properly
supported or fixed.
Never use a cut-off wheel for deburring.
Make sure that sparks cannot hit any
persons or set flammable materials alight.
Always wear safety goggles, hearing protection
and if necessary other protective means, such as
working gloves, coat, hard hat, etc.
Mount the screening guard. Never use the
machine without screening guard fitted.
Make sure that the ventilation openings
are kept clean. Especially when working in
a dusty environment.
- Before removing dust always unplug
the tool.
- Do not use brushes of metal or the like to remove
dust and avoid damaging the internal parts.
Beware that after switching off the tool the
wheel continues to rotate for a short period.
ELECTRICAL SAFETY
Always check that the power
supply corresponds to the
voltage on the rating plate.
DESCRIPTION
Your angle grinder has been designed for
grinding and cutting masonry and steel.
1 On/off switch
2 Lock knob
3 Spindle
4 Guard
5 Side handle
6 Carbon brush holder
Mounting and removing the guard
First remove the guard as described below.
Place the guard (4) on the machine as shown.
Tighten screw (6) firmly.
To remove the guard, proceed in reverse order.
Never use the machine
without guard.