Battery Replacement - Ecom Lite-Ex PL 10 H Bedienungsanleitung

8.3 Battery replacement

The batteries should be replaced if the level of luminance is
no longer deemed to be satisfactory.
It is advisable to change all 3 batteries at the same time.
Only the appropriate, approved types of batteries may be
used (see Table 1).
To replace the batteries turn the left-hand side cap (which
bears the „ecom" inscription) in the direction of the arrow
and then remove the entire battery adapter (see fig. 2).
You can then remove and exchange the batteries. After
inserting the new batteries (while observing the correct
polarity) the battery adapter can be reinserted (please ob-
serve the guides in the adapter and battery compartment
when doing this). Then screw the cap back on.
Please make sure the lamp has been screwed together
completely before switching it on again.
Fig. 2
Battery replacement
- Only use type-tested batteries
(see the table 1 under point 7: Technical specifications)
- Always replace all batteries simultaneously.
- Pay attention to the correct polarity.
- Dispose of depleted batteries in an appropriate and
environmentally friendly manner!
- When changing the batteries examine the threads and
seals for cleanliness and signs of damage.
- If you notice any spilled electrolyte when changing the
battery, do not take the unit into the Ex-area, but send it
to the manufacturer for inspection.
22