LENCO DVT-1541 Bedienungsanleitung Seite 14

System Connections
Connecting to a PC
Follow the steps and the figure below to connect a PC to the unit:
1. Connect one end of the VGA cable to the VGA input jack on the right side of the unit's rear
panel and the other to the PC.
2. Connect one end of the audio cables to the PC audio input jack on the right side of the unit's
rear panel and the other to the PC audio output jack.
3. Set the PC's resolution at 1024×768 and the refresh frequency at 60Hz.
After connection, turn on the unit and the PC and then press the INPUT button to select VGA mode.
- 13 -