HANSGROHE Talis S2 32040000 Montageanleitung Seite 21

Important! The fitting must be installed, flushed and
tested after the valid norms!
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the sink.
3. Slip the slide washer, washer and collar nut
over the threaded base and tighten the collar
nut by hand.
4. Tighten screws.
5. Connect the supply pipes to the isolation
valves; cold right - hot left.
6. 32040000/320443000/32044000/32240000/32
244000: Connect the pull rod to the pop-up
waste.
The hot and cold supplies must be of equal
pressures.
Operation
The mixer is activated by lifting the lever handle.
Turning to the left = warmer water,
turning to the right = cooler water.
Technical Data
This mixer series-produced with waterdimmer®
(flow limiter).
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 14 l/min 0,3 MPa
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Test certificate
English
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPa.
If the continuous water heater causes any problems
or there is not enough flow of water, the
waterdimmer® (5a) located behind the aerator must
be removed.
Mitigeur avec limitation de la température: consulter
la page 6 pour le réglage
Une limitation de la température n'est pas
nécessaire quand le mitigeur est alimenté par un
chauffe-eau instantané.
Spare parts (see page 4)
1
1.1 screw cover
2
3
4
5
6
7
8
9
10
11
7 l/min 0,3 MPa Special accessories
max. 1 MPa X special tool set
0,1-0,5 MPa (order as an extra)
1,6 MPa
max. 80°C
65°C
WRAS
handle
flange
nut
cartridge cpl.
seal
aerator cpl.
fixing set
connection hose
pull rod
ball joint
connection hose
32096000
96338000
97406000
97209000
92730000
95008000
13912000
96016000
96321000
96657000
92036000
97206000
97206000
5