Georges Renault PC6.48C Bedienungsanleitung Seite 7

INSTRUCTIONS
Before using or servicing the power tool, the supply of
compressed air must be disconnected or shut off.
For user's liability and safety, any modification in the tool or its
accessories must first be approved by the manufacturer. All
safety regulations applicable in each country relating to
installation, operation and maintenance shall always be met.
The tool is fully stopped only several seconds after the on/off
system has been released.
The tool is designed for a working pressure of 6.2 bar (90
psig). The compressed air must be clean. The installation of a
filter is recommended.
performance, comply with the specification of the air hose.
(Refer to figure no.1 for compressed air connection)
Ømini mm = 8 (5/16")
The use of spare parts other than those originally supplied by
the manufacturer may result in a drop in performance or in
increased maintenance and in the full cancellation of the
manufacturer's liability.
To obtain maximum efficiency from the pneumatic tool,
preserve its features and avoid repeated repairs, a routine
inspection and repair programme is
intervals between the various inspections depending on the
amount of exertion on the power tool.
- Disassemble the tool, clean and check the parts carefully.
- Check the condition of the bearings and inspect the vanes
for wear and surface condition.
Check the free speed of the tool at regular intervals and after
each use. Remove the tool or the accessory to check the
speed. The maximum speed shown on the tool must not be
exceeded.
This tool is fitted with vanes which can operate without
lubricated air. However, a small amount of oil allows the tool
to provide full power and lengthens its life.
The use of dry air with no trace of oil may reduce the life of
vanes.
1
6159946900-00
PC6.48C – PC6.32C
PC6.21C – PC6.13C
For maximum efficiency
7 m max.
recommended, the
and
7