Data Transmission; Power Supply Via The Usb Port; Cleaning; Storage - Holex 49 2928_2000 Bedienungsanleitung

35

6.3. DATA TRANSMISSION

en
MASS-STORAGE MODE
1. Connect the video endoscope to a PC using a USB cable.
2. Switch on the video endoscope.
▶ The screen will show and .
3. Use or to navigate in to select .
4. Press to confirm.
▶ Images and videos can be transmitted to the PC.
i
mode can also be activated via and "USB".

6.4. POWER SUPPLY VIA THE USB PORT

1. Remove the batteries.
2. Connect the video endoscope to the power supply using a USB cable.
3. Switch on the video endoscope.
4. Press .
▶ The video endoscope is now ready for use.

7. CLEANING

Before starting to clean the video endoscope, remove the batteries. Clean
the video endoscope with a moist cotton cloth. Ensure no liquids penetrate
the ports. Refer to the cleaning instructions in the operating instructions for
the camera probe.
Do not use alcoholic, abrasive or solvent-based cleaning agents.

8. STORAGE

Store in the original packaging, protected from light, free of dust in a dry
place.
Store at temperatures between 0 °C and +60 °C. When storing the probe, do
not coil it to a diameter less than 15 cm.
www.hoffmann-group.com