Werbung
Verfügbare Sprachen
Verfügbare Sprachen
62005SB
Paint and varnish removal
Turn on the gun and allow it to reach full heating power. Hold the nozzle 3" to 4" from the
paint to be moved. After short time, paint will soften and begin blistering. Do not
overheat paint, as this will cause buring and make the finish more difficult to remove.
When stripping paint overhead, always use eye protection.
Being scraping the paint off working from top to bottom. Use scrapers. Scrape with
smooth, Even strokes, warming the surface in front of the scaper by moving the gun
slightly from side to side. If paint is warmed properly, even thick layers can be removed
in a single pass. Paint should come off in a strip equal in width to the scraper blade.
Clean the edge of the scraper regularly to keep it clean and sharp and to prevent paint
from building up on the blade. Scrape the paint as soon as it soften since it will quickly
harden again.
Shaped or profiled surfaces can be stripped with a wire brush after softening with the hot
air jet.
Cover all surfaces not be heated with non-flammable material. Never concentrate tool`s
heat on a window panel or other glass surface.
Caution:
Lead paint fumes are very harmful. Always provide adequate
ventilation while working indoors!
SW-Stahl und Werkzeugvertriebs GmbH
Leverkuser Strasse 65
D-42897 Remscheid
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
www.swstahl.de
Werbung
