Operation - SW-Stahl 62005SB Bedienungsanleitung

62005SB

Operation

A
A
Accepts accessory nozzles
B
Heat guard
C
Two Speed switch control
D
Ventilation opening
Using heat gun
This product is very light and easy to use. The variable heat control allows for low to
high working temperature setting. Before plugging into the electrical outlet, make sure
the power switch is in the off position.
When ready to work set switch to on and set variable heat control to desired
temperature settings. Allow a minute or so or to reach its operating temperature.
This heat gun is designed with a built in a stand so it can be positioned in an upright
(vertical) position only, on any flat, level surface. This frees both hands to easily shape
moldmaterials.
SW-Stahl und Werkzeugvertriebs GmbH
Leverkuser Strasse 65
D-42897 Remscheid
C
B
Tel. +49 (0) 2191 / 46438-0
Fax +49 (0) 2191 / 46438-40
E-Mail: info@swstahl.de
D