Grasslin talento taxxi plus Bedienungsanleitung Seite 12

1
Hold the taxxi directly
on the two IR diodes
(hold the taxxi still
during this operation)
Press the corresponding key twice, depending on the transfer direction –
in or out
• Press the key once. The transfer is prepared and the relevant program
• Press the key again. The data is transferred. An audible signal is output
If the data has been correctly transferred, the number of the program location,
e.g. P_ 1, can be seen in the display (of the taxxi).
If the data has not been correctly transferred, there is a short, audible signal and
the corresponding error message Er x appears in the display (see Section 5).
location and the assignment
in or out flash alternately
during the transfer.
GB