Installation - Fractal design TESLA 550W Bedienungsanleitung

Installation

Please read through this entire manual before proceeding with the in-
stallation.
Warning! Do not connect AC power cord before the last step!
1. Install the power supply according to the manual of your computer
case, with the enclosed mounting screws.
2. Connect the 20/24-pin cable to the motherboard. The 20/24-pin ca-
ble header has a detachable 4-pin connector if you have an older
motherboard with only 20-pin connection.
3. Connect the 4pin +12V (also called P4-cable) cable to the mother-
board. If your motherboard instead has an 8-pin socket, connect
the 8-pin (also called EPS12V-cable) cable to it.
Warning! The detachable 4-pin cable from the 20/24-pin cable is not a
P4/+12V connector. Serious damage can occur if you use the detach-
able 4-pin instead of the P4/+12V connector.
4. Connect the peripheral cables to IDE-connected drives if you have
such (older HDD and optical drives).
5. Connect the SATA power connectors to SATA-connected drives
(newer HDD and optical drives)
6. Connect the floppy connector if you have a floppy drive
7. Connect the AC power cord to the Fractal PSU and turn on the on/
off switch.
WARNING!
Always operate the power supply in a safe and dry environment.
Never insert any objects into the open ventilation or fan grill area!
Hazardous voltages inside power supply! Never remove the cover. War-
ranty is voided once the cover is removed.
TM
Fractal Design
5