Installing The Au12 Unit; Transport And Handling - ECOFOREST AU12 Installations-Und Technische

Hydraulic installation
Installation and subsequent interventions on the hydraulic circuits must only be performed by authorised personnel in accordance
with applicable local regulations and the instructions provided in this manual.

Do not touch the pipes while or immediately after the unit is in operation; this may result in
burns caused by intense cold or heat. If these components need to be touched, allow sufficient
DANGER!
time for the temperatures to stabilise and wear protective gloves to avoid injury.
Electrical system
Any intervention on the electrical system must only be performed by an authorised electrician in accordance with applicable local
regulations and the instructions provided in this manual.

Before performing any operation on the unit, disconnect the power supply.

During
DANGER!
the electrical panel unattended while it is exposed.

Do not touch any component of the electrical panel with wet hands as this could cause an
electric shock.

Do not open the top cover while the fan is running. Disconnect the electrical supply before
doing so.
DANGER!

Do not place fingers or any sharp object through the front screen of the unit while the unit is in
operation. Disconnect the electrical supply before performing any tasks on the unit.

Do not touch the rear screen of the unit. This could cause cuts or burns.
Scrapping
The AU12 aerothermal unit is built with a variety of different materials and must therefore be delivered to an authorised centre for
proper scrapping and recycling of said materials.

2. Installing the AU12 unit

2.1. Transport and handling


Due to its heavy weight, the heat pump should be handled by at least two workers using a
forklift for heavy loads.
NOTE
installation and maintenance
23
AU12 Installation Manual and Technical Service
of the equipment never leave