Important Advice - REV 00715 Anleitung

Read this manual carefully before using this product and check whether there are any damaged parts.
The product has not to be installed in case of damages. Keep this product out of reach of children or any
unauthorized persons. At the end of its lifetime, dispose of the product correctly. Electronic components
have to be disposed of as no standard landfill.
The packaging includes:
Halogen floodlight projector with a spike 150W or 500W
Suitable bulb
How to use the halogen floodlight projector
Installation of the bulb
1. Make sure that the projector is not connected to the power supply.
2. Remove the upper screw from the projector's
casing and remove the front glass.
3. Take the bulb out of its packaging. Do not touch
the bulb with your bare hand. Use a towel to fix the bulb into the fitting. First press one side of
the fitting against the metal pin and shift the pin backwards so that you can press the other side of
the bulb against the metal pin.
4. After changing the light bulb, please pay attention to the correct positioning of the seal.
5. Fix the front glass with the screw.
A.

Important advice

Before using the device, check carefully whether you have installed the correct type of bulb.
Before using the device, make sure that all screws have been fixed with a torque of 0,8Nm.
The bulb and the halogen floodlight projector will get extremely hot when using them. Avoid any contact
during the use of the device.
Do not use the halogen floodlight projector near inflammable objects as these can catch fire because of
the extreme heat of the halogen floodlight projector. Keep the mentioned security distance.
After turning off the halogen floodlight projector, let it cool down for 20 minutes before touching the
projector.
Do not use the projector without a correctly installed safety glass (danger of injuries when the bulb
explodes).
Not suitable for heavy use.
Protect the cable from contact with sharp objects, chemicals or hot surfaces.
The halogen floodlight projector has to be fixed into solid soil. Otherwise the projector can tip over and
damage objects.
Do not install the projector in room areas where electric components can be flooded with water when it
starts raining.
When you install the projector near a water tank, a safety distance of at least 0,5m has to be kept.
The cable should only be replaced by an expert in the field of electrical installation.
Halogen floodlight projector with a spike
B.
1.
2.
C.
GB