Dali PHANTOM E-50 Bedienungsanleitung Seite 9

UK DE DK CN FR
Objects positioned between the speaker and listening position might negatively affect the sound
quality. the PHANtOM E series are designed to meet our wide dispersion sound principle. By using
speakers with wide dispersion technology, the distortion in the main listening area will be lowered
and the room integration will be better. the wide dispersion principle will also ensure that sound
is spread evenly within a large area in the listening room.
Every room has its own distinctive acoustics, which influence the way we experience sound from a
speaker. the sound you hear consists of both direct sound from the speakers and reflected sound
from the floor, ceiling and walls. the latter will affect how you experience the sound. As a basic
rule, try to avoid large, hard and reflective areas in the immediate vicinity of your loudspeakers as
it will typically cause strong reflections, which might disturb the precision and spatial effect of the
sound reproduction. Soft items such as carpets, curtains etc. might help if the sound is too bright..
Both the amount and quality of the deep bass depend on the size and shape of the room, and the
position of the speakers. Positioning the speakers near a side or back wall will accentuate the
bass. A corner location will accentuate it even more, but will also increase the reflections.
4.1 Mounting the dogleg brackets
DALI PHANtOM E series incorporates dogleg brackets for ceiling/wall mounting. the brackets
attach the loudspeaker firmly to the rear of the surface on which it is mounted. the dogleg brackets
extend out at a 90-degree angle when the screws are tightened (see figure 4). the screws should
be tightened so that the loudspeaker sits securely in place – but be careful not to over tighten the
screws. to tighten the screws, use a 3mm Allen bit. the Allen bit should be used with a hand bit
screwdriver or a drilling machine with build-in torque setting. If using a drilling machine, set the
torque to the minimum setting. the screws are appropriately tightened, when the gasket on the
rear of the speaker is compressed and the bezel of the speaker is flush with the mounting surface.
If you need to remove the loudspeaker, loosen the screws approximately 5 to 20 turns counter
clockwise and the brackets will loosen their grip. NOtE: do not unscrew more than 20 to 25 turns
or the brackets may fall off the screws.
If you are mounting the loudspeaker in very thick wall material, it might be needed to dismount the
dogleg brackets from the screws and afterwards mounting them upside down. Opposite mounting
of the doglegs will make it possible to mount the loudspeaker in boards with up to 2,55"/65 mm
thickness (see figure 5).
4.2 Grille
the front grille is fixed in place by the magnets incorporated into the front baffle of the DALI
PHANtOM E series.
NOtE: there is an optional square grille available for order.
NOtE: On the inside of the grille there is a piece of non-woven. the non-woven is on the grille
to protect the drivers against dust and dirt. therefore the non-woven must remain on the grille.
9