Maintenance - Plantui 6 smart garden Bedienungsanleitung

English
Setting up
Check our Youtube channel @plantuicom for instruction videos.
Before setting up the device:
Pull off the Light Unit (13) from the Watering Unit (15). Lift off the Watering Unit (15) from the water
bowl (16).
1. Add water & nutrients
1a. Add 3 liters of water with 3 spoonfuls of nutrients to the water bowl (16). The spoon is
attached on the box. The nutrients are in the Plant Capsule package. Do not exceed the 3 liter
water limit line! 1b. Place the Watering Unit (15) to the water bowl (16).
2. Place plant capsules
2a. Remove the centers of the labels. 2b. Place the capsules to the six empty holes. NOTE:
Do not leave any holes empty, except the seventh hole, which is only for adding water. We
recommend to grow plants with the same growing time together. You can see the growth
timelines on each Plant Capsule package.
3. Plug in the device
3a. Plug in the device. 3b. Put on the Light Unit (13) without a Height Block (14). Pink lights turn
on, the germination phase has begun. You can hear the first irrigation start. It's time to grow!

Maintenance

4. Sleeptimer
Plantui Smart Gardens sleep for 8 hours daily. The device will go automatically to sleep after
16 hours from turning it on. The timer can be readjusted, if necessary. Set the sleep timer by
holding your hand on top of the Light Unit (13) for 3 sec - lights will blink 2 times and then turn
off.
5. Height Blocks TM
Add the first Height Block (14) when the first leaves appear. Add the 2nd Height Block before the
leaves touch the Light Unit (13).
6. Water & nutrients
If the pump starts to be noisy, the water level is low. You can check the water level by lifting up
the Watering Unit (15) by the handles. Mix 2 spoonfuls of nutrients with 2 liters of water and pour
the solution into the water hole. When water has run out completely, Plantui flashes blue lights.
NOTE: The water level should not exceed 3 liters.
2