Alternating Measurements; Good Laboratory Practice; Data Storage In The Internal Memory; External Storage In A Computer Using Usb Or Rs232 - Consort T8710 Anleitung

1. Select the menu by pressing MODE.
2. Select [ALTERNATE] and press CAL to activate or deactivate. The display
alternates between the selected modes with an interval of ca. 5 s.
3. Press MODE to return to the measurements.
1. Press CAL while measuring.
2. Select [GLP] and press CAL.
3. Browse with çè é ê to show a complete calibration report. Press STORE to
print the report.
1. Select the menu by pressing MODE.
2. Select [DATALOGGER] and press CAL.
Start the data-logging
1. Select [STORE] and press CAL.
2. Select [ACTIVATE] and press CAL.
3. Select [YES] or [NO] and press CAL.
4. Select [INTERVAL] and press CAL.
5. Select the desired time interval between the data-logging (or MANUAL) and
press CAL.
6. Select [ALARM] and press CAL.
7. Select the desired time interval between the data-logging (or MANUAL), when
the alarm is activated, and press CAL.
8. Select [NUMBER] and press CAL.
9. Select the desired number of values to be data-logged and press CAL.
10. Press MODE to return to the measurements and to start the data-logging
according to the previous settings. When manual data-logging has been
selected, press STORE to put a next measurement into memory. In the
meantime the display shows the logging-number e.g. [#00027].
View the stored values on the display
1. Select [RECALL] and press CAL.
2. Select [TABLE] or [PRINT] to display or print the stored data and press CAL to
continue. Follow the intructions on the screen.
3. In case [TABLE] have been selected press CAL to show the options.
4. Select [LOG#] and press CAL. Select the number of the first line to be shown
on the display and press CAL.
5. Select [SHOW] and press CAL. Select [Log#] (line numbers) or [Date] to be
shown on the display and press CAL.
Erase the stored values
1. Select [ERASE] and press CAL. Follow the intructions on the screen.
1. Select the menu by pressing MODE.
2. Select [USB/RS232] and press CAL.
3. Select [BAUDRATE] and press CAL.
4. Select the desired baudrate and press CAL.
5. Select [INTERVAL] and press CAL.
6. Select the desired interval between the transmitted data and press CAL. Pre-
set to zero if no automatic transmitting is required.
7. Select [ALARM] and press CAL.
8. Select the desired interval between the transmitted data, when the alarm is
activated, and press CAL. Pre-set to zero if no automatic transmitting is
required.
9. Select [IDENTIF. No.] and press CAL.
10. Enter an identification number for the transmitted data and press CAL.
• You can download free software and a suitable USB driver from www.consort.be.

Data Storage in the internal memory

External storage in a computer using USB or RS232

4

Alternating measurements

Good Laboratory Practice