Werbung
Verfügbare Sprachen
Verfügbare Sprachen
While 4x4 is being activated, the display shows "4x4: shifting ON". After
successful switching the display shows "4x4: ON".
Driving in all-wheel drive mode:
As soon as the all-wheel drive is activated, the control lamp next to the
button lights up and the display shows "4x4: ON". Warning lamps in the
instrument cluster indicate that the ESP and ABS are deactivated. The
notices "CHECK ABS" and "CHECK ESP" are displayed on the text out-
put.
Function
1
Instrument cluster
Starting at a speed of 50 km/h, a beep sounds every 2 seconds. An addi-
tional display messages asks the drive to reduce speed.
78
Status
Symbols
Warning lamps for
deactivation ESP
and ABS
All-wheel drive deactivation:
The all-wheel drive can be deactivated at any time by pressing the
4-wheel-drive button "4x4".
During the switching process, the control panel shows "4x4: shifting OFF".
As soon as the red control lamp next to the 4-wheel-drive button "4x4"
turns off and the display shows "4x4: "OFF", the process is complete and
the vehicle is in 4x2 mode.
ESP is automatically reactivated after turning off the all-wheel
drive. In order for the system to initialize as quickly as possible,
the speed should be less than 20 km/h and pronounced stee-
ring or braking should be avoided. As soon as the signal lamps
in the instrument cluster turn off, the brake control system is fully
available again.
If the all-wheel drive cannot be turned on or off, the switching
process can be sped up in the following ways:
• Provoke a load change (start driving, brake)
• Drive in a slight curve
• Stop, briefl y put in reverse and start driving, drive a slight
curve if necessary, then drive forward again.
Errors activating the all-wheel drive are shown on the display of
the control panel in the centre console.
Operating Manual
All-wheel drive, gear reduction
BG
CS
DA
DE
EL
EN
ES
ET
FI
FR
HR
HU
IS
IT
LT
LV
NL
NO
PL
PT
RM
RU
SK
SL
SV
79
Werbung
Kapitel
