This Product Specific Safety Rules - Nitto Kohki delvo DEA0151N-AZ Bedienungsanleitung

 Plug the power plug securely all the way in to an electrical outlet.

An improperly connected power plug could overheat, and dust adhering to the plug could cause a fire or electric
shock.
Metal pieces adhering to an improperly connected power plug could also result in a fire or electric shock.
 Tools with a ground wire need to be grounded properly.

Tools that are not grounded properly could cause an electric shock.
 Follow the instructions for lubricating and changing accessories.

 Inspect tool cords periodically and if found to be damaged have them repaired by an authorized service facility.

 Inspect extension cords periodically and replace if damaged.

 Keep handles dry, clean and free from oil and grease.

 Before further use of tool, it should be carefully checked to determine that it will operate properly and perform its

intended function.
 A guard or other part that is damaged should be properly repaired or replaced at an authorized service center

unless otherwise indicated in this instruction manual.
 Have defective switches replaced by an authorized service center.

 The use of any accessory or attachment other than those recommended in this instruction manual could present a

risk of personal injury.
 Do not remove the label or nameplate on the tools.

If labels or nameplates are broken or peeling, for a replacement label or nameplate contact the retailer where you
purchased the tool.

This Product Specific Safety Rules

WARNING
 Make sure to check the connectable electric screwdriver in the "Electric screwdriver model list".

Never connect an electric screwdriver model which is not in the list, a product other than an electric screwdriver or a
product of another company.
Doing so could cause a fire or accident.
 Use the tools indoors.

This tool is not dust and leak-proof. Exposure to dust, sand, or rain while using it outdoors could cause a failure.
 If the tool is accidentally dropped or hit, check to ensure there is no breakage, cracking or deformation.

Breakage, cracking or deformation could cause electric shock or injury.
 When the tool becomes overheated, or you notice anything abnormal during usage, switch it OFF immediately and

request that the tool be repaired.
 Before starting work, make sure there is no flammable materials around the device.

Flammable materials could cause a fire or accident.
About Unit Notation
This instruction manual is written using both SI units and the imperial measurement method (yards, pounds).
Numeric values outside the ( ) are the value in SI units, while those inside the ( ) are the imperial measurement
value.
Notation Example: Length 25.4 (1") Weight: 0.45 (1)
in
mm
Torque: 1.13 (10)
lbs
kg
EN
Lb·in
Nm
3