Nitto Kohki delvo DEA0151N-AZ Bedienungsanleitung Seite 4

EN
 If devices are provided for connection of dust extraction and collection facilities, ensure these are connected and

properly used.
Use of dust collection can reduce dust-related hazards.
<Power tool use and care>
 Do not force the power tool. Use the correct power tool for your application.

The correct power tool will do the job better and safer at the rate for which it was designed.
 Do not use the power tool if the switch does not turn it ON and OFF.

Any power tool that cannot be controlled with the switch is dangerous and must be repaired.
 Disconnect the plug from the power source or battery pack from the power tool before making any adjustments,

changing accessories, or storing power tools.
Such preventive safety measures reduce the risk of starting the power tool accidentally.
 Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these

instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
 Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other

condition that could affect power tool operation. If damaged, have the power tool repaired before use.
Many accidents are caused by poorly maintained power tools.
 Keep cutting tools sharp and clean.

Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control.
 Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into account the

working conditions and the work to be performed.
Use of the power tool for operations different from those intended could result in a hazardous situation.
<Service>
 Have your power tool serviced by a qualified repair person using only identical replacement parts.

This will ensure that the safety of the power tool is maintained.
<Additional Safety Warnings>
 Dress properly. Wear protective hair covering to contain long hair.

 Never touch any moving parts of the tool when the tool is running.

Also, do not direct the tip of moving parts toward people or animals.
 Be aware of tool vibration and recoil. Some tools can cause a considerable amount of vibration.

Depending on how the product is operated, the type of tool setting, and the length of operation, it could place a
tremendous burden on your hands, arms and body.
The tool could cause a vibration injury or tendonitis. Avoid long-term use and take appropriate breaks.
Consult a doctor if you experience any discomfort or pain during operation.
 Do not use the tool at home.

This is a professional tool (industrial or work tool for business). Do not bring the tool home and use it there.
 When work has to be done in high locations, make sure there is nobody underneath the work area.

If the tool or material is dropped, it could cause an accident or injury.
 Before starting operation, make sure that there is no conduit, water pipe or gas pipe by your work area.

If a tool touches a buried object, it could cause electrical shock or leakage, which could cause an accident.
 Always use a power supply that provides the power displayed on the label or nameplate.

 Use a sine wave power supply with a power fluctuation rate within ±10% of the rated supply voltage and a

frequency of 50/60HZ.
 Do not force small tools to do the job of a heavy duty tool.

 Do not use tools for purposes not intended; for example do not use circular saws to cut tree limbs or logs.

 Where possible use clamps or a vise to hold the work. It is safer than using your hand.

 Do not allow the following chemicals to come into contact with the tool, as parts could deteriorate.

Acetone, benzine, thinner, ketone, ether, trichlorethylene and other similar chemicals
 Do not store the cord by wrapping it around the main unit.

Doing so could damage the cord.
 Make sure the power plug does not have any dust or metal material adhering to it.

If dust or metal material is found on the power plug, disconnect the power plug and wipe it away with a dry cloth.
If the tool is used without removing such material, it could cause a fire or electric shock.
2