Control Panel - Clatronic KHF 558 Bedienungsanleitung, Garantie

5....-05-KHF 558
GB
1 Head band
2 Headphones
3 ON/OFF switch
4 Channel selector
5 Volume control
6 Receiver diode
7 Battery compartment
8 Charger jack
9 Cover for battery compartment
10 Power diode
1. Insert the antenna cable in the rod antenna (16) and place the rod carefully into
the housing.
2. Connect the 3.5 mm audio stereo cable (17) to the corresponding output of your
radio source, e.g. television set, CD or DVD player. If your audio source has two
RCA outputs (red and white), please use the Y adapter cable (18).
3. Connect the free end of the audio stereo cable (17) to the AUDIO IN socket of
your transmitter.
4. Connect the power pack (19) to a properly installed 230V/50Hz safety power
socket and then connect the plug cable to the DC IN socket of the transmitter.
5. If the transmitter is connected in this way, it switches itself on automatically as
soon as a signal is received from the audio source. The power LED (10) then
lights up in red and shows the operating status. It is best to place the transmitter
in a cool dry place at eye level.
Important note: The transmitter has an AUTO-off function. If the input signal is
very quiet or switched off, the transmitter will switch off automatically after
approx. 120 seconds.
6. Insert two batteries of type R03 • AAA • UM4 1.5V into the battery compartment
of the headphones (batteries not supplied). Please ensure that the polarity is
correct (see the floor of the battery compartment or the inscription on the outsi-
de)! If the device is not used for a long period of time, remove the batteries to
avoid the spilling of battery acid. Close the battery compartment and switch the
headphones on by the switch (3).
7. Switch on the audio source (e.g. television set, CD or DVD player).
8. Turn the channel selector switch until the channel diode shows the best possi-
ble reception by means of the green light. Turn the volume regulator (5) to set
the desired volume.
30
04.06.2003 15:07 Uhr

Control panel

11 Charger diode
12 Channel selector
13 Jack AUDIO IN
14 Jack DC IN
15 Charger jack
16 Rod antenna
17 Audio-stereo lead, 3.5 mm
18 Y-adapter 3.5 mm
19 Power pack
20 Charger lead
Installation
Seite 30