Renson Oxyvent Montageanleitung Seite 17

Remove the gauge and screws. Screwfix the coupling onto the inner flap of the Oxyvent
4
using the connection rod between the coupling and the interior profile. Make use of screw
n° 3.
5
Slide the base of the motor control over the connection rod (using the space in the base).
6
Turn the base 90° untill the right location (as shown on the drawing).
7
Then screwfix the base onto the Oxyvent with 4 screws. Make use of screw n° 1.
®
Oxyvent en
®
,
®
17