Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
f. Switch on and off (Fig.6)
The tool is equipped with a lock-off button to avoid unintentional starting.
Before plugging the tool into the power point always checks that the
!
trigger switch and lock-off button work properly.
WARNING
Fig. 6
g. changing the blade (Fig.7)
Always ensure that the machine is switched off and plug is removed
!
from the power supply before making any adjustment.
WARNING
Fig. 7
•
To switch on, depress the lock-off
button and squeeze the trigger
switch.
•
To switch off, release the trigger
switch.
•
Blades can be reversed when blunt.
•
After both sides of the blades have
been used they should be replaced.
•
NOTE: These blades cannot be re-
sharpened.
1. Using the spanner supplied, loosen all
the clamping screws.
2. Slide out the blade. Clean out all chips
or foreign matter adhering to the
cutter block and the blade.
3. Either turn over the planer blade or
replace it if required.
4. Slide the good blade face up into the
blade retainer of the cutter block. The
ridge along the blade should be on the
opposite side to the clamping screws.
Werbung
Inhaltsverzeichnis
