ZENEC ZE-5.1D Bedienungsanleitung Seite 24

9. Mute On/OFF
This function is to enable or disable muting of the decoder output. When mute is enabled, this is
indicated on the screen until it is disabled. To disable mute, use the „MUTE" button once more, or
the master „VOLUME UP", „VOLUME DOWN" button respectively.
10. Setup Menu Display
Controlling DRC, Pro Logic, crossover, line input levels and each channel level is only possible in
the setup menu. For more information, refer to the previous expalanations of this section. When
the setup menu is invoked, the following display is shown.
-> PRO LOGIC ON/OFF
-> DRC ON/OFF
-> CROSSOVER XXXHz*
-> INPUT1 LEVEL X V**
-> INPUT2 LEVEL X V
-> CHANNEL LEVEL
* XXXHz of Crossover is 60Hz to 220Hz in 10Hz steps
** X V has the range of 0.2 – 6V
Movement of arrows in the left column is achieved by pressing the „MENU UP" or „MENU DOWN"
button. When a function is selected, the arrow corresponding to the function is blinking. The On or
Off status is controlled by „MENU RIGHT" or „MENU LEFT" button. In this case, both buttons act
identically. The adjustment of the cutoff frequency for the crossover filter is also made by „MENU
RIGHT" or „MENU LEFT" button. However, the left button is used for decreasing frequency and
right button for increasing in this case. The „SETUP" button is used to enable and disable setup
menu.
11. Channel Level Control Menu Display
As the sub-menu of setup menu, the following menu for channel level control is provided. To view
this sub-menu, move to „CHANNEL LEVEL" in setup menu using „MENU UP" or „MENU DOWN"
button. Then, push the „ENTER' button on the remote control unit.
-> FRONT LEFT XX dB*
-> FRONT RIGHT XX dB
-> CENTER
-> REAR LEFT
-> REAR RIGHT XX dB
-> WOOFER
* XX dB is -10 to +10dB in dB steps
The selection of channels is identical to the selection of functions in the setup menu. The level
change is made by „MENU LEFT" and „MENU RIGHT" buttons. The left button is used for value
decreasing and the right button for increasing, exactly indetical to the adjustment of the crossover
filter frequency. To escape the channel sub-menu, press the button twice. The first push is to
return to setup menu from this sub-menu, while the second push lets you leave the escape setup
menu.
XX dB
XX dB
XX dB
24