Herunterladen Inhalt Inhalt Diese Seite drucken

ZENEC ZE-5.1D Bedienungsanleitung Seite 23

5.1 kanal digital-endstufe
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

6. Channel Level Control
The menu system provides the ability to control each channel's input level from -10dB to +10 dB
in 1 dB steps. This trim control can be used for matching levels of different types of speakers, or
used when more power is required.
To enable channel level menu and to control values,
1) Push „SETUP" button.
2) Move blinking arrow to „CHANNEL LEVEL" using „MENU UP" or "MENU DOWN" button.
3) Push the „Enter" button on the remote controller. The window for channel level control will
open.
4) Move the blinking arrow to the channel to be controlled using the „MENU UP" or „MENU DOWN"
button
5) For level increasing, use the „MENU RIGHT" button, and the „MENU LEFT" button for level
decreasing.
6) After finished, push the „SETUP" button to escape channel window and push the „SETUP"
button again to completely escape setup menu.
7. Test Tone On/Off
To use the test tone function, the master volume should be increased to a relatively high playback
level, because the output level of the test tone is relatively low.
To enable or disable the test tone output,
1) Push the „TEST TONE" button on the remote control. The test tone will be output to one channel
at a time in the order of „FRONT LEFT à CENTER à FRONT RIGHT à REAR RIGHT à
REAR LEFT" continuously. While the test tone is playing, pressing any other function button does
not work.
2) To output normal sound, push „TEST TONE" button again. The test tone mode is then disabled
to produce normal audio output.
Note: Test tone does not include a tone for the SUB channel. Checking the connechon of SUB
speaker is only possible with real audio sound through the SUB speaker.
8. Master Volume Up/Down
This controls the output level of all channels simultaneously It is designed to control in 1dB steps
for high volume levels, or in 2dB steps for middle levels and in 3~5dB for low levels. When volume
level is lowered far enough, the output is muted. A short push of the „VOLUME UP" or „VOLUME
DOWN" button will change the volume one step up or down, while pressing down the Volume
button will result in multiple step changes.
23

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis