Honeywell HB 95 Montage Und Bedienung Seite 33

2. Activating binding at the brightness sensor module
To check whether the radio connection is ready for later op-
eration, the brightness sensor module should remain as near
as possible to the mounting site during binding.
Remove the brightness sensor module
►
from the mounting bracket.
Open the battery compartment.
►
Press the Binding button briefly (see
►
figure on Page 34, Item 1).
Close the battery compartment and
►
insert the brightness sensor module
into the mounting bracket.
The brightness sensor module is as-
signed to the Hometronic Manager
HCM 200D.
Commissioning
31