Installing The Batteries - Party Light & Sound PARTY-15RGB Bedienungsanleitung

EN
Use of the Remote Control
⠗ Please operate the remote control within a distance of 6m and 30° between the remote and the appliance.
Aim the remote at the sensor. Remove all obstacles between the remote and the sensor.
⠗ The remote control might not work properly if the sensor is exposed to strong sunshine.
⠗ If the remote control doesn't work properly, please check the batteries.

Installing the Batteries

Remove the battery cover from the back of the remote control
as shown and insert 2x AAA size batteries ensuring correct
polarity
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but depo-
sited in separate collection points for recycling.
ATTENTION!
Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
WARNING!
Do not swallow the battery. Danger of chemical burns.
(The supplied remote control of) This product contains a button cell. In case of ingestion, it might cause se-
rious internal burns within only 2 hours that might lead to death.
Keep new and old batteries out of the reach of children.
If the battery compartment doesn't close properly, stop using the product and keep it out of the reach of
children.
If you are in doubt whether the batteries have been swallowed or introduced into any other part of the body,
contact immediately a doctor.
Description of the rear panel controls (see page 2)
1. Master volume control
2. BASS control: Adjustment of low frequencies
3. TREBLE control: Adjustment of high frequencies
4. Microphone volume control
5. Echo control for the microphone
6. Input for a wired mic (not supplied)
7. Switches the LED on the woofer on /off
8. When the power adaptor is connected, the indicator lamp will be lit a and the battery will charge
9. Wireless mic antenna: when you use the wireless microphone, please make sure the antenna is pointing
vertically upwards to optimize the reception.
10. 12V battery input: please make sure to connect the external battery with the correct polarity (+ and -). The
cable section must not be smaller than 0.75mm².
11. AUX input via 3.5mm Jack
12. Input selector: Press this button to switch between the various inputs (AUX, USB, TF, Bluetooth, FM)
13. REC button: Press this button to record the sound of the wired or wireless mic on the USB or SD.
14. REPEAT: Press to toggle between repeating the current track or repeating all tracks.
15. In USB/TF/Bluetooth mode: press to go back to the previous track. In FM mode: press to go to the previously
stored FM station.
16. Play/pause in USB/TF/Bluetooth mode. In FM mode, press and hold this button to start searching for radio
stations and store them automatically in the memory
17. In USB/TF Bluetooth mode: press to go to the next track. In FM mode: press to go to the next stored FM sta-
tion.
18. USB stick input
19. ON/OFF switch of the system
20. 15Vdc input connector
21. TF card input
22. Lights up when the LED light effect on the woofer is switched on
5