whisbear CRYsensor Bedienungsanleitung Seite 4

SWITCHING ON DIRECTLY IN CRYsensor MODE
EN
It is possible to bypass the initial 40-minute shushing and start the device directly in the 3-hour stand-by mode with the
CRYsensor function. To do so, press and hold the button for about five seconds until you hear a beep. This indicates that
the device is on and is in stand-by mode and will start shushing when it detects a baby's cry.
Press and hold for about 5 sec
until you hear a beep
ADJUSTING VOLUME LEVEL OF THE SOUND DEVICE
Adjust the sound volume according to your baby's needs. For volume adjustment, switch the device on and wait for
the volume to stabilize (the Soft Stop/ Soft Start function), press the button again and hold for at least 3 seconds. The
volume will start to increase until it reaches the maximum level. Press and hold again to decrease sound until it reaches
minimum level.
Press briefly
to start shushing
Release the button
after the beep
Press and hold
to turn up the volume when the volume is right
The device is on and will start shushing
only after crying is detected
Release the button Press and hold again
to turn down the volume
Release the button
when the volume is right