Function Description; Use And Function; Remote Control; Pairing Mode - Sana lithium pack HIGH POWER Gebrauchsanweisung

FUNCTION DESCRIPTION

sana lithium pack
The battery packs have three operating modes: POWER OFF – STANDBY – IN USE.
▪
They are indicated with the heat setting display (Fig. 1.2) on the battery packs and
the remote control. The number of illuminated LEDs corresponds to the selected
heat setting.
POWER-OFF:
The battery packs are completely turned off and the heat setting display (Fig. 1.2)
▪
is permanently off.
They can only be switched on with the control button (Fig. 1.3) of the battery
▪
packs.
Note:
The battery packs cannot be switched manually to POWER OFF mode!
IN USE:
The battery packs supply energy to the connected textile.
▪
STANDBY:
The heat setting display (Fig. 1.2) briefly flashes at an interval of 2.5 seconds.
▪
The battery packs are in stand-by and can be activated with the control button of
▪
the battery packs (Fig. 1.3), via the sana heat app* (Smartphone).

USE AND FUNCTION

Turning on/off:
Turn on the product on the lowest heat setting by briefly pushing (approximately 0.5
seconds) the control button on the battery pack (Fig. 1.3).
– 26 –
Push the control key repeatedly to switch to the next higher setting and back to
standby mode after level 3.
The respective heat setting is indicated by the flashing of the heat setting display
▪
(Fig. 1.2) on the battery pack.
LED flashing – standby (no heating power)
LED steady on – low heating power
LEDs steady on – meduim heating power
LEDs steady on – high heating power
If there is no heated textile or charger connected to the battery packs, the battery
packs will automatically switch to POWER OFF mode after 12 hours!
(If you are using the sana heat app* to control your battery packs remotely, the app
must also be closed on your smartphone in order for the battery packs to be able to
successfully switch to POWER OFF mode.)

REMOTE CONTROL

The sana lithium packs can be controlled via the sana heat app* for smartphones.
The batteries must be in "Pairing Mode" to be able to couple them properly with the
smartphone.

Pairing Mode

Please switch the desired batteries to "Pairing Mode". For this purpose, push the
control button (Fig. 1.3.) for approx. 10 seconds until the heat setting displays
(Fig. 1.2.) are blinking and then immediately release the control button. The heat
setting display in the middle is flashing constantly.
LED steady on – Pairing
Note: The Pairing Mode remains active for 2 minutes! If no pairing takes place during
this time, this mode will end automatically!
– 27 –