Technical Specifications; First Use And Charging; Charging Process; Safety Functions - Sana lithium pack HIGH POWER Gebrauchsanweisung

TECHNICAL SPECIFICATIONS

Global USB power supply Input: 100 V - 240 VAC
unit
(50/60 Hz), max. 150 mA
(with exchangeable plug)

sana lithium pack

FIRST USE AND CHARGING

Important note:
The battery packs must be charged before using them for the first time.

Charging process

1. Connect the charging cable with the USB power supply unit and plug the USB
power supply unit into a socket. The charge indicator (Fig. 2.2) will light up green.
2. Remove the contact protector (Fig. 1.4) and connect both battery packs to the
charging plugs of the charging cable (Fig. 2.4). Please refer to the diagram on the
charging plugs for correct orientation. The battery packs can be charged in any
operating mode.
3. The charging process starts after one-time operation of the control button
(Fig. 1.3.).
4. The charge indicator (Fig. 2.2) will light up red during the charging process.
5. Once the battery packs are fully charged, the charging process automatically ends
and the charge indicator (Fig. 2.2) changes back to green.
6. The charging status can be monitored by looking at the LEDs on the battery pack,
which will light up in ascending order as the charge increases. It can also be
optionally monitored with the sana heat app* convenient control app.
7. After the end of the charging process, please disconnect both battery packs from
the charging plugs.
Output: 5V / 1A DC
Output: 3,7 V / 3600 mAh
– 24 –
Important note:
The percentage indicator in the sana heat app* may show slightly different
▪
charging statuses during charging mode, as battery packs are subject to
production tolerances by nature. These minimal differences will have no impact
on the product's heating output or heating duration.
If you are using a USB power unit other than the USB power unit included by the
▪
manufacturer, it must meet the mentioned technical specifications and comply
with all applicable safety standards and guidelines.
Charge the product after every use. This helps extend the life of the batteries and
▪
ensures that the product is ready for use at any time.
The battery consists of lithium ion cells and can be charged in any state. For this
▪
reason, the battery does not need to be fully discharged before charging.
The full charging capacity of the product can only be conserved if the product is
▪
disconnected from the charging plugs after the end of the charging process.
Charging time lithium pack high power

SAFETY FUNCTIONS

Short circuit protection: In the event of a short circuit at the contact or the
▪
heating element, the product's integrated electronics system automatically turns
off. After removing the short circuit, please connect the batteries briefly with the
charging plugs. Next, press the control button once and the product is ready again.
▪ Protection against overcharging and exhaustive discharge: The product is
protected against overcharging and exhaustive discharge with the integrated
electronics system.
7 – 9 h
– 25 –