Baker Hughes Druck PV 211 Bedienungsanleitung Seite 8

2.1 Hose/Adaptors (Figure #1)
To attach a hose (5) and adapter (6) to a connector (4), turn the knurled nut on the connector
counterclockwise.
2.2 Pressure Release Valve (Figure #1)
Use this (1) to reduce or release the pressure in the system. The amount of turn sets the rate
to release the pressure. Only minimum force is necessary to seal the system.
2.3 Fine Adjust Vernier (Figure #1)
INFORMATION
adjust vernier (2) farther than the red line indicator on the thread. See item
11 in Figure #2.
To make accurate adjustments to the pressure, turn the fine adjust vernier (2) clockwise to
increase the pressure or counterclockwise to decrease the pressure.
2.4 Pressure/Vacuum Selector (Figure #1)
Before you change the mode, make sure that the pressure release valve (1) is open. To
change the mode, use an applicable tool to push the selector (3) to the side specified on the
label.
2.5 Overpressure Protection (Figure #1)
To adjust the maximum output pressure of the system, turn the nuts (8) to increase or
decrease the stroke length.
4 | PV 211 Instruction Manual-English
To prevent damage, DO NOT use force to turn the fine
© 2005 Baker Hughes, a GE company – All rights reserved.