General Specification; Safety Precautions - Baker Hughes Druck PV 211 Bedienungsanleitung

5. General Specification

INFORMATION
steel, bright nickel plated brass, anodized aluminum, phosphor bronze
(springs), nitrile rubber seals and nylon.
Item
Pneumatic Pressure Range
Vacuum Pressure Range
Dimensions (Length x Width x Depth)
Weight (approximate)
a. This value assumes atmospheric pressure at 1 bar (14.5 psi) and varies depending on atmospheric pressure.
6. Returned Goods Procedure
If the unit requires calibration or is unserviceable, return it to the nearest GE Service Centre
listed at: www.gemeasurement.com
Contact the Service Department to obtain a Return Authorization (Worldwide excluding
USA).
In the USA, obtain a Return Material Authorization [RMA].
Provide the following information on either a RGA or RMA:
• Product (i.e. PV 211)
• Serial number
• Details of defect/work to be undertaken
• Operating conditions

6.1 Safety Precautions

INFORMATION
warranty and may not guarantee further performance.
You must inform GE if the product has been in contact with any hazardous or toxic substance.
The relevant COSHH or in the USA, MSDS, references and precautions to be taken when
handling.
© 2005 Baker Hughes, a GE company – All rights reserved.
Pneumatic gases must be compatible with stainless
Specification
0 to 40 bar (0 to 600 psi)
0 to -0.95 bar
220 mm (8.7") x 105 mm (4.1") x 63 mm (2.5")
0.65 kg (1.4 lb)
Service by unauthorized sources will affect the
a a
(0 to -28 inHg)
PV 211 Instruction Manual-English | 7