Special Information - AEG Haustechnik EWH 50 Trend Bedienung Und Installation

sPeciAl informAtion

oPerAtion
1. General information .................................................. 14
2. Safety .......................................................................... 14
3. Appliance description ............................................... 15
4. settings ....................................................................... 15
5. Cleaning, care and maintenance ............................. 15
6. troubleshooting ........................................................ 16
instAllAtion
7. Safety .......................................................................... 16
8. Appliance description ............................................... 16
9. Preparations ............................................................... 16
10. Installation .................................................................. 17
11. commissioning .......................................................... 18
12. Shutting down ............................................................ 18
13. troubleshooting ........................................................ 18
14. Maintenance ............................................................... 19
15. Specification .............................................................. 20
wArrAnty
enVironment And recycling
sPeciAl
informAtion
- The appliance may be used by children
aged 8 and up and persons with reduced
physical, sensory or mental capabilities or a
lack of experience and know-how provided
that they are supervised or they have been
instructed on how to use the appliance safe-
ly and have understood the resulting risks.
Children must never play with the appliance.
Children must never clean the appliance or
perform user maintenance unless they are
supervised.
- Only use a permanent connection to the
power supply. The appliance must be able
to be separated from the power supply by
an isolator that disconnects all poles with at
least 3 mm contact separation.
- The power cable must only be replaced (for
example if damaged) with the original spare
part by a qualified contractor authorised by
the manufacturer.
- Fix the appliance in position as described in
the chapter "Installation / Preparations".
- Observe the minimum and maximum water
inlet pressure (see chapter "Specification /
Data table").
Contents - Special information
- The appliance is under pressure. During the
heat-up process, expansion water will drip
from the safety valve.
- Regularly activate the safety valve to pre-
vent it from becoming blocked e.g. by limes-
cale deposits.
- Drain the appliance as described in the
chapter "Installation / Maintenance / Empty-
ing the appliance".
- Install a type-tested safety valve in the cold
water supply line. For this bear in mind that,
depending on the static pressure, you may
also need a pressure reducing valve.
- Size the drain so that water can drain off
unimpeded when the safety valve is fully
opened.
- Fit the discharge pipe of the safety valve
with a constant downward slope and in a
room free from the risk of frost.
- The safety valve discharge aperture must
remain open to the atmosphere.
13