Operation - Heathrow Scientific Magnetic Bedienungsanleitung

Operation

1. Remove the contents from the package, examining them carefully for
breakage, defects, or missing parts. Save the packaging.
Note: Specially designed stir bars are included. Optimal geometry
provides quiet and efficient stirring.
2. Positioning: place stirrer on a sturdy, stable, level surface near a
grounded electrical outlet away from the edge of the counter and
other moving equipment. The surface should be clean. Position
stirrer so that it is easy to disconnect from mains outlet. Allow
sufficient clearance on all sides of the unit for proper ventilation and
usage. Ensure no person or hazardous substances are within 12"
(30 cm) zone around unit. Make sure the power cord is clear of hot
surfaces and other hazards.
3. Prior to every use, inspect unit for cracks, missing pieces, or any
damage that would result in impaired performance and notify
manufacturer BEFORE use. Make sure the power switch on the rear
of the unit is set to "O" which stands for "OFF"
4. Place flexible pad on top of stirrer to keep container in place and to
dampen noise.
5. Place stir bar into bottom of empty container (see warning on
page 8).
6. Carefully fill container with all fluids to be mixed, note the level of
the liquid which will rise to accommodate the spinning vortex of
fluid when unit is powered. Be sure to leave sufficient room at the
container top for this rise in fluid level.
7. Center the mixing container on top of the stirrer. When turned on, the
magnet will find center.
8. Turn on unit with rear power button.
Note: To reset device, press and hold knob for 3 seconds.
6
1. Main On/Off Switch
2. Power Input Connector