Phonocell 6/831 Bedienungsanleitung Seite 8

ACTIVATION
Battery-Recharging
The very first battery recharging has to be done for a period of at least 8 hours: after the first 3 hours, LED 3 will switch-off but the
current-supply needs to go on for another 5 hours.
All subsequent battery-rechanging operations will be completed within 4 hours.
We recommend to take out the battery whenever the device remains idle for more than 2 weeks.
When the 6/831 is used to localize or trace a vehicle, it is necessary to effect the GPS-fixing before starting to reveal the position.
The best GPS-signal is obtained under the open sky, so that the 6/831 should possibly be placed behind the windscreen.
Effect the battery recharging by means of the supplied re-charger or cigar-lighter. It is possible to re-charge the device also
through a PC/Notebook USB-pin.
Switch-On
Press key ON/OFF until the LEDs 2 and 4 switch-on.
If the battery-charge-level is sufficient, the blue and green lights will remain permanently lighted and the switch-on-process will
be completed.
A pause of 1 second is required between the switch-on and the switch-off. In other words, if switch-off has taken place and switch-
on is made immediately (by pressing On/Off), the device will NOT switch-on. In such case, release the ON/OFF-key, wait for at
least 1 second, then repeat the switch-on operation.
Coupling with a Bluetooth-device
- Effect the coupling-procedure by carefully following the Instructions Manual of the involved manufacturer (of handy, PDA or else).
- Effect the research for BLUETOOTH ACCESSORIES from the device.
- Select BT-GPS from the list of the involved devices, and activate the connection.
- On request, insert the PIN-number 0000.
Allow the 6/831 to connect automatically, if requested by the device. This way, it will not be necessary to repeatedly research and
activate the Bluetooth-connection.
Some navigation-softwares do not allow an automatic re-connection, so that re-connection has to be made manually.
Functioning
Position the 6/830 on the dashboard, with ON/OFF-key and LED-indicators looking towards the windscreen. After the switch-on,
the device will look for the GPS-signal and, consequently, also for all available satellites.
To be able to start navigation on whichever device, it is necessary that the GPS reveals the starting position (fixing). The reveal-
ing-time for the Fixing-position can change from one switch-on to another, in relation with the temperature.
Under certain environmental conditions (example, under a tunnel, on city-streets, among very high buildings), the GPS-signal
might be weaker than normal or even disappear.