Bimar RQ-8209 Bedienungsanleitung Seite 8

Fax +32 2 359 95 50
hands of children as they are potential sources of danger; dispose of them according to
the regulations in force.
•
Before plugging in the appliance, check that the voltage printed on the lable
corresponds to that of the power grid. In case of any incompatibility between the socket
and the plug of the appliance, only have the plug substituted by another suitable type by a
qualified professional who ascertains that the diameter of the cord is suitable for the power
consumed by the appliance. Verify that the electrical wires are not connected to other
appliances of high consumption, to avoid overloads and the risk of fire. In general it is not
advisable to use adapters and/or extension cords; if their use is absolutely necessary, they
must comply with the applicable safety standards and their range of current (amps) must
not be less than the maximum of the appliance..
• Before every use check that the appliance is in good condition, and that the electrical cord
has not been damaged: in case of doubt consult a suitably qualified professional.
• Do not twist the power cord around the appliance.
• The power outlet should be readily accessible so that you can easily disconnect the plug in
case of an emergency.
• Always unplug the power cord after use.
•
Don't pull the cord to move the appliance. Make sure the electrical cord cannot get
caught to avoid the hairdryer falling. Do not wrap the cord around the appliance and do not
twist it.
•
Do not leave the appliance hanging by the cord, but use the appropriate suspension
ring.
•
This appliance is not intended to be operated by means of an external timer or a
separate remote control system, in order to avoid the risk of fire in case the appliance is
covered or not placed in the correct position .
•
Do not connect the appliance to a thermal system of control, or programmer, or
timer or any other device that can automatically turn the appliance on, thus avoiding the
risk of damage to individuals, animals or objects.
•
In case of breakdown or malfunction turn the appliance off and have it checked by
a qualified professional; repairs made by individuals who are not qualified could be
dangerous and invalidate the guarantee.
•
To ensure greater safety, we recommend that you install a 30 mA differential in
the electrical circuit that supplies the bathroom. Consult your service assistance technician
or a similarly qualified person, in order to prevent any risk.
USE
Before every use make sure that the appliance is in good condition, that the electrical cord
has not been damaged: if the power cord is damaged, it must be substituted by the
manufacturer or by a service assistant technician, or by a person of similar qualifications, in
order to prevent any risk.
During the first use, smoke may escape from the appliance. This poses no danger to the
user and is not a defect of the appliance. After about 30 seconds the smoke will stop
coming out. If this phenomenon is prolonged, you should contact the technical support
service to have them check the appliance.
1) Put the plug into the electrical socket.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar s. The
pages must be reproduced and folded in order to obtain a
booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
8
Assembly page 8/24