AGPtek BH2B Bedienungsanleitung Seite 5

3) Select "G28 R". If asked for a pass code, enter 0000.
Earbuds will automatically connect to the last paired
device when the earbuds are on and Bluetooth is
activated on the device. If not, you can attempt to
connect to the last paired device by pressing MFB
button.
 Pairing H2 earbuds separately with two devices
1) When using the earbuds for the first time, press
and hold the Multi-function button and LED of the
earbuds will flash in red and blue alternatively,
indicating the earbuds are under pairing mode.
2) Turn on the Bluetooth of your phone. It will search
for new devices nearby automatically.
3) Select "G28 R/G28 L". If asked for a pass code,
enter 0000.
Earbuds will automatically connect to the last paired
device when the earbuds are on and Bluetooth is
activated on the device within the effective range.
Tips: Your buds automatically power down after about
10 minutes of non use.
1. MFB button
Power on/off
automatically
When Charge Case is on, your buds
automatically power on as soon as
you take them out of the Case and
power off as soon as you place
them into the Case.
4